SN74HC373APWR
| Parameters | |
|---|---|
| Number of Bits | 8 |
| Propagation Delay | 220 ns |
| Turn On Delay Time | 15 ns |
| Logic Function | D-Type, Latch |
| Output Characteristics | 3-STATE |
| Current - Output High, Low | 7.8mA 7.8mA |
| Logic Type | D-Type Transparent Latch |
| Max I(ol) | 0.006 A |
| Independent Circuits | 1 |
| Delay Time - Propagation | 12ns |
| Length | 6.5mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 6 Weeks |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 20 |
| Weight | 76.997305mg |
| Operating Temperature | -40°C~85°C |
| Packaging | Tape & Reel (TR) |
| Series | 74HC |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Subcategory | FF/Latches |
| Packing Method | TR |
| Technology | CMOS |
| Voltage - Supply | 2V~6V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Terminal Pitch | 0.65mm |
| Base Part Number | 74HC373 |
| Output Type | Tri-State |
| Operating Supply Voltage | 5V |
| Circuit | 8:8 |
| Polarity | Non-Inverting |
| Power Supplies | 2/6V |
| Load Capacitance | 50pF |
SN74HC373APWR Overview
In the 20-TSSOP (0.173, 4.40mm Width) package, it can be found as an embedded module. The package is in the form of Tape & Reel (TR). In its configuration, Tri-State is used as the output. This electrical device has Logic type D-Type Transparent Latch. A Surface Mount mount is used for mounting this electronic part. There is no supply voltage for this device. A temperature of -40°C~85°C is set as the operating temperature. This FPGA is part of the 74HC series. 8 Bits are used in the design of this electronic part. This device has 20 terminations. As a member of the 74HC373 family, it falls under that category. The pin configuration of the device is 20. It is mounted according to the Surface Mount method. Subcategory FF/Latches contains this part. There are 2/6V power supplies required for this machine to operate. Considering the reliability of this device, it would be a good candidate for TR. A high level of efficiency is achieved by maintaining the supply voltage at 5V.
SN74HC373APWR Features
20-TSSOP (0.173, 4.40mm Width) package
74HC series
8 Bits
74HC373 family
20 pins
2/6V power supplies
SN74HC373APWR Applications
There are a lot of Texas Instruments SN74HC373APWR Latches applications.
- Frequency
- Hammer
- Display
- Timers
- Network Switches
- Storage
- Clocks
- High-speed logic
- Parallel Input
- Address register