MAX4592EUE
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2000 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Terminal Finish | Tin/Lead (Sn85Pb15) |
| Additional Feature | CAN ALSO OPERATES AT 15 V SUPPLY, OVERVOLTAGE PROTECTION |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 4 |
| Supply Voltage | 12V |
| Terminal Pitch | 0.65mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4592 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| JESD-30 Code | R-PDSO-G16 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 16V |
| Power Supplies | 12/15V |
| Number of Channels | 1 |
| Number of Circuits | 4 |
| On-State Resistance (Max) | 20Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 72 dB |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 9pF 9pF |
| On-state Resistance Match-Nom | 0.5Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 80ns, 45ns |
| Charge Injection | 2pC |
| Channel-to-Channel Matching (ΔRon) | 500m Ω |
| Crosstalk | -85dB @ 10MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 90ns |
| Switch-off Time-Max | 50ns |
| Voltage - Supply, Single (V+) | 3V~16V |
| Normal Position | NO |
| Height Seated (Max) | 1.1mm |
| Length | 5mm |
| RoHS Status | Non-RoHS Compliant |
MAX4592EUE Overview
Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. Advanced packaging method Tube is used to provide high reliability. Mounted in Surface Mount is this multiplexer. 1:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around -40°C~85°C TA. In total, there are 16 terminations. As a result of its 1 channels, this electronic component provides high-quality output. In the case of a voltage supply of 12V volts, the electrical part can be powered up and run. The electrical component body receives 16 pins. SPST - NO switching circuits are used in these analog switch ics. There are 4 circuits in this multiplexer. Try searching with MAX4592 if you're looking for variants. The analog multiplexer shown here is a typical Multiplexer or Switches. A voltage of 3V~16V is required to drain this analog switch from a single voltage supply. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. Don’t miss additional features of the electronic component such as: CAN ALSO OPERATES AT 15 V SUPPLY, OVERVOLTAGE PROTECTION.
MAX4592EUE Features
1 Channels
Switch Circuit: SPST - NO
Additional Features: CAN ALSO OPERATES AT 15 V SUPPLY, OVERVOLTAGE PROTECTION
MAX4592EUE Applications
There are a lot of Maxim Integrated MAX4592EUE Analog Switches & Multiplexers ICs applications.
- DSLAMs
- Imaging
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- MP3 players
- E1 Multiplexer
- Audio and video signal routing
- Avionics test equipment
- ISDN NT1/TA
- SONET/SDH ADM
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads