MAX4173FESA
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C |
| Packaging | Tube |
| Published | 2009 |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Subcategory | Other Analog ICs |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 1 |
| Supply Voltage | 12V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | 20 |
| Base Part Number | MAX4173 |
| Pin Count | 8 |
| JESD-30 Code | R-PDSO-G8 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 28V |
| Power Supplies | 5V |
| Supply Voltage-Min (Vsup) | 3V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Adjustable Threshold | NO |
| Current - Supply | 420μA |
| Amplifier Type | Current Sense |
| Current - Input Bias | 700μA |
| Voltage - Supply, Single/Dual (±) | 3V~28V |
| Voltage - Input Offset | 300μV |
| -3db Bandwidth | 1.4MHz |
| Length | 4.9mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
MAX4173FESA Overview
In order to protect the op amps, a 8-SOIC (0.154, 3.90mm Width) case is used. There are two types of operational amplifiers in this circuit. Instrumentation amplifier is delivered in a Tube case. A total of 8 terminations have been reported in the past few weeks. In this case, there are 8 pins on the board. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 12V. Instrumentation amplifier is a part of Other Analog ICs. This electrical part should be mounted using type Surface Mount. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~85°C . There are 1 circuits on op amps. The op amp ic has 1 channels on it. As a result, it is recommended that a power supply of 420μA be used with this electronic part. An analog IC known as a POWER SUPPLY SUPPORT CIRCUIT is the other type of IC that is used in this op amp ic.
MAX4173FESA Features
8 Pins
supply voltage of 12V
MAX4173FESA Applications
There are a lot of Maxim Integrated MAX4173FESA Instrumentational OP Amps applications.
- Blood pressure sensors
- Navigation
- PDA
- High-frequency data acquisition systems
- Signal operation
- Displayers for aircraft and air transportation control systems
- pH (acidity)
- Inverse/same-phase proportional circuit
- Band-pass filter
- Communication