MAX323CUA+
| Parameters | |
|---|---|
| Factory Lead Time | 6 Weeks |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Number of Pins | 8 |
| Operating Temperature | 0°C~70°C TA |
| Packaging | Tube |
| Published | 1998 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 60Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 727mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX323 |
| Output | SEPARATE OUTPUT |
| Pin Count | 8 |
| Power Supplies | 3.3/5V |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 16V |
| Min Supply Voltage | 2.7V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 100pA |
| Max Supply Current | 100pA |
| Throw Configuration | SPST |
| Turn On Delay Time | 150 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 100 ns |
| On-State Resistance (Max) | 60Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 72 dB |
| Channel Capacitance (CS(off), CD(off)) | 9pF 9pF |
| On-state Resistance Match-Nom | 0.8Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 150ns, 100ns |
| Charge Injection | 1pC |
| Channel-to-Channel Matching (ΔRon) | 800m Ω |
| Crosstalk | -85dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 2.7V~16V |
| Normal Position | NO |
| Height Seated (Max) | 1.1mm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MAX323CUA+ Overview
Presented in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), this electrical component is convenient for overseas shipping. The advanced packaging method Tube provides high reliability. This analog switch is mounted in Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. An extended operating temperature of 0°C~70°C TA degrees Celsius. Totally, there are 8 terminations. The electronic part provides high-quality output because it has 1 channels. An 5V voltage supply should allow the electrical part to be turned on and run. A key feature of the 8 series is the inclusion of this electronic part as part of its design. Based on SPST - NO switching circuits, these analog multiplexers work. 2 circuits are used in this analogue multiplexer. Try searching with MAX323 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 60Ohm. The functions of 8 pins can be found in the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. normally, users should not supply switches with voltages higher than 16V. A cost-effective Single supply type analogue multiplexer. It is recommended to use 2.7V as the lowest voltage for the electrical part. 1μA current would be enough for this multiplexer to operate. A voltage of 2.7V~16V is required for this switch device, which drains from a single voltage source. The switch multiplexer may be damaged if it is exposed to voltage greater than 100pA. The digital multiplexer has SEPARATE OUTPUT outputs that can be used.
MAX323CUA+ Features
1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
MAX323CUA+ Applications
There are a lot of Maxim Integrated MAX323CUA+ Analog Switches & Multiplexers ICs applications.
- SONET
- Transmit
- CSU
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- SDH/SONET multiplexers
- Microprocessor controlled systems
- Audio and video switching
- PBXs
- E1 Multiplexer
- Precision data acquisition