ISL43L841IRZ-T
| Parameters | |
|---|---|
| Factory Lead Time | 6 Weeks |
| Mount | Surface Mount |
| Number of Pins | 16 |
| Published | 2004 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 2 |
| Number of Terminations | 16 |
| Resistance | 480mOhm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | QUAD |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Pin Count | 16 |
| Operating Supply Voltage | 3V |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 2 |
| Max Supply Voltage | 4.5V |
| Min Supply Voltage | 1.65V |
| Analog IC - Other Type | DIFFERENTIAL MULTIPLEXER |
| Operating Supply Current | 20nA |
| Max Supply Current | 50nA |
| Propagation Delay | 42 ns |
| Turn On Delay Time | 50 ns |
| Logic Function | Demultiplexer, Multiplexer |
| Supply Type | Single |
| Turn-Off Delay Time | 27 ns |
| Off-state Isolation-Nom | 65 dB |
| On-state Resistance Match-Nom | 0.12Ohm |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 34ns |
| Signal Current-Max | 0.3A |
| Height | 750μm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
ISL43L841IRZ-T Overview
In total, there have been 16 terminations. As a result of its 2 channels, this electronic component provides high-quality output. Powered by a 3V voltage supply, the electrical part should be switched on and run. A key feature of the 16 series is the inclusion of this electronic part as part of its design. Internally, this switch multiplexer has a resistance of 480mOhm. The datasheets for the 16 pins explain the functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 4.5V. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 1.65V. For this multiplexer to operate, 20nA current would be sufficient. Put voltage above 50nA on the multiplexer to cause damage. An analog IC with the number DIFFERENTIAL MULTIPLEXER is integrated into this board. 3V operating voltages can be used with this electrical part. During operation, the multiplexer should not be exposed to a temperature above 85°C.
ISL43L841IRZ-T Features
2 Channels
20nA Supply Current
ISL43L841IRZ-T Applications
There are a lot of Intersil (Renesas Electronics America) ISL43L841IRZ-T Analog Switches & Multiplexers ICs applications.
- Industrial control systems
- Cellular phones
- Wireless Local Loop
- Avionics and Military Systems
- Audio and video switching
- High-Voltage
- Audio and video signal routing
- Medical Instrumentation
- Switching Systems
- Transmit