IDT74FCT2374CTQG
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SSOP |
| Number of Pins | 20 |
| Published | 2009 |
| JESD-609 Code | e3 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 20 |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | FF/Latches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.635mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 20 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Power Supplies | 5V |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Load Capacitance | 50pF |
| Number of Ports | 2 |
| Number of Bits | 8 |
| Propagation Delay | 5.5 ns |
| Turn On Delay Time | 2 ns |
| Family | FCT |
| Output Characteristics | 3-STATE WITH SERIES RESISTOR |
| Logic IC Type | BUS DRIVER |
| High Level Output Current | 12mA |
| Low Level Output Current | 15mA |
| Clock Edge Trigger Type | Positive Edge |
| Width | 3.937mm |
| RoHS Status | RoHS Compliant |
IDT74FCT2374CTQG Overview
The flip flop is packaged in SSOP. A total of 1elements are present in it. There are 20 terminations,The power supply voltage is 5V. In terms of electronic devices, this device belongs to the FCTfamily of devices. In this case, the electronic component is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. This device exhibits a clock edge trigger type of Positive Edge. The RS flip flops belongs to FF/Latches base part number. The flip flop is designed with 8bits. An electrical current of 5V volts is applied to it. A D flip flop with 2embedded ports is available. In order to achieve high efficiency, the supply voltage should be maintained at 5V. There is 12mA output current at the high level. 15mA is the low level output current. A temperature below 85°Cis recommended for operation. It is recommended that the operating temperature is higher than -40°C. The RS flip flop is designed to operate with a minimal supply voltage of 4.75VV. The maximum supply voltage supported by the flip flop is 5.25V. BUS DRIVERis used as the logic IC in this D flip flop. A total of 1 functions are available on the T flip flop. 20pins are available on this JK flip flop.
IDT74FCT2374CTQG Features
20 pins
8 Bits
5V power supplies
1 Functions
20 pin count
IDT74FCT2374CTQG Applications
There are a lot of Integrated Device Technology (IDT) IDT74FCT2374CTQG Flip Flops applications.
- Differential Individual
- Common Clocks
- Shift Registers
- Pattern generators
- ESD performance
- Frequency Dividers
- Bus hold
- Event Detectors
- Test & Measurement
- Memory