EPCS16SI8N
| Parameters | |
|---|---|
| Factory Lead Time | 14 Weeks |
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 8 |
| Weight | 540.001716mg |
| Published | 2005 |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 |
| Number of Terminations | 8 |
| ECCN Code | 3A991.B.1.B.1 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 1.27mm |
| Frequency | 20MHz |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 8 |
| Operating Supply Voltage | 3.3V |
| Temperature Grade | INDUSTRIAL |
| Interface | Serial |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 2.7V |
| Memory Size | 2MB |
| Operating Supply Current | 50μA |
| Memory Type | FLASH |
| Supply Current-Max | 0.015mA |
| Frequency (Max) | 40MHz |
| Organization | 16MX1 |
| Memory Density | 16777216 bit |
| Endurance | 100000 Write/Erase Cycles |
| Height | 1.65mm |
| Length | 4.9mm |
| Width | 3.9mm |
| Radiation Hardening | No |
| REACH SVHC | Unknown |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
EPCS16SI8N Overview
SOIC is used in this package.A maximum of 2MB bytes of data can be stored.3.3V is the voltage it requires as a supply.FPGA is possible to connect different functions on the 8 axis at different terminations.The temperature should be kept below 260 in reflow soldering.FPGA has 8 pins.The memory chip is allowed to operate at a voltage that is no greater than 0.015mA.There is a set of 8 pins that are included with the part.3.3V recommends that users apply 3.3V to the part before using it in a circuit so it can run safely and reliably.This type of memory is called a FLASH memory.This is an application suitable for Surface Mount-based operating systems.Using the switching controller, you will be able to move the slider at a frequency of 20MHz.There is a possibility of operating the device at a temperature as low as -40°C.The temperature of the ambient environment should not be higher than 85°C for it to operate properly.The voltage used to run it should be at least 2.7V.Memory is rated 3.6V for maximum supply voltage.Using 50μA, it operates.
EPCS16SI8N Features
FLASH memory
Frequency: 20MHz.
EPCS16SI8N Applications
There are a lot of Altera EPCS16SI8N applications of configuration proms for FPGAs.
- eSRAM
- DVD disk buffer
- personal digital assistants
- cell phones
- workstations,
- personal computers
- Camcorders
- servers
- mainframes
- nonvolatile BIOS memory