ALD4213PCL
| Parameters | |
|---|---|
| Factory Lead Time | 8 Weeks |
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Number of Pins | 16 |
| Supplier Device Package | 16-PDIP |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2016 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 135Ohm |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Max Power Dissipation | 600mW |
| Number of Circuits | 4 |
| Max Supply Voltage | 12V |
| Min Supply Voltage | 3V |
| Nominal Supply Current | 10nA |
| Max Supply Current | 1μA |
| Turn On Delay Time | 300 ns |
| Voltage - Supply, Single/Dual (±) | 3V~12V ±1.5V~6V |
| Turn-Off Delay Time | 1.5 μs |
| Max Dual Supply Voltage | 6V |
| On-State Resistance (Max) | 135Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 3pF 3pF |
| Switch Circuit | SPST - NO/NC |
| Switch Time (Ton, Toff) (Max) | 130ns, 130ns |
| Charge Injection | 0.2pC |
| Channel-to-Channel Matching (ΔRon) | 2.7Ohm |
| Crosstalk | -90dB @ 100kHz |
| RoHS Status | ROHS3 Compliant |
ALD4213PCL Overview
Packed in 16-DIP (0.300, 7.62mm), the electronic component is convenient for shipping overseas. This high-reliability packaging method uses advanced packaging methods Tube. The multiplexer is located in Through Hole. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operational temperature extended around -40°C~85°C TA. These analog multiplexers are built based on SPST - NO/NC switching circuits. 4 circuits are used in this analogue multiplexer. Internally, this switch multiplexer has a resistance of 135Ohm. The datasheets for the 16 pins explain the functions. Multiplexers should not be powered above 12V in normal situations. The lowest voltage fed to the electronic component should be 3V. The analogue multiplexer may be damaged if voltage is greater than 1μA. If put voltage greater than 6V on the multiplexer, damage may be caused to the device. The switches should not operate in an environment where the temperature is higher than 85°C. Suppliers offer 16-PDIP packages.
ALD4213PCL Features
Switch Circuit: SPST - NO/NC
ALD4213PCL Applications
There are a lot of Advanced Linear Devices Inc. ALD4213PCL Analog Switches & Multiplexers ICs applications.
- T1/E1 Terminals
- PBX interfaces
- Low-Voltage
- Fault Tolerant Systems
- Relay replacements
- Communication systems
- FTTH
- Cell phones
- Automotive applications
- Fiber In The Loop (FITL)