ADG821BRMZ
| Parameters | |
|---|---|
| Channel-to-Channel Matching (ΔRon) | 160m Ω |
| Crosstalk | -82dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 67ns |
| Voltage - Supply, Single (V+) | 1.8V~5.5V |
| Drain to Source Resistance | 500mOhm |
| Normal Position | NO |
| Height | 850μm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Contains Lead |
| Factory Lead Time | 8 Weeks |
| Lifecycle Status | PRODUCTION (Last Updated: 1 month ago) |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Surface Mount | YES |
| Number of Pins | 8 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tube |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 600mOhm |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 5μW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3.6V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | ADG821 |
| Output | SEPARATE OUTPUT |
| Pin Count | 8 |
| Power Supplies | 3/5V |
| Number of Channels | 2 |
| Interface | Parallel |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Nominal Supply Current | 2μA |
| Power Dissipation | 5μW |
| Max Supply Current | 2μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 45 ns |
| Supply Type | Single |
| Bandwidth | 24MHz |
| Turn-Off Delay Time | 16 ns |
| On-State Resistance (Max) | 600mOhm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 52 dB |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 85pF 98pF |
| On-state Resistance Match-Nom | 0.16Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 45ns, 16ns |
| Charge Injection | 15pC |
ADG821BRMZ Overview
Shipping overseas is convenient due to the electrical component's packing in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). The advanced packaging method Tube provides high reliability. It is mounted in the position Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. The operating temperature is extended to around -40°C~125°C TA. 8 terminations have been made so far. The electronic part provides high-quality output because it has 2 channels. Turning on and running the electrical part should be easy with a 3.6V voltage supply. 8 pins are injected to the electronic part body. These analog multiplexers are built based on SPST - NO switching circuits. Use ADG821 to search for variants of the digital switches. The internal resistance of this digital multiplexer is 600mOhm. The functions of 8 pins can be found in the datasheets. Multiplexer or Switches is a typical switch device. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. Single supply type digital switch with a low cost. The lowest voltage fed to the electronic component should be 1.8V. The voltage required by this switch device is 1.8V~5.5V, draining from a single voltage supply. If you put voltage higher than 2μA on the digital multiplexer, damage may occur. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. 24MHz-bandwidths can be used to transfer data between multiplexers. It has a Drain to Source resistance of 500mOhm ohms.
ADG821BRMZ Features
2 Channels
Switch Circuit: SPST - NO
Bandwidth: 24MHz
Drain-to-Source resistance: 500mOhm
ADG821BRMZ Applications
There are a lot of Analog Devices Inc. ADG821BRMZ Analog Switches & Multiplexers ICs applications.
- Modems
- Avionics test equipment
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Signal routing between systems
- Mechanical reed relay replacement
- Precision test equipment
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- SONET
- Battery Powered Systems
- Access Concentrators