ADG1412YRUZ
| Parameters | |
|---|---|
| Factory Lead Time | 8 Weeks |
| Lifecycle Status | PRODUCTION (Last Updated: 1 month ago) |
| Contact Plating | Tin |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Surface Mount | YES |
| Number of Pins | 16 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tube |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 1.8Ohm |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 4.97mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | ADG1412 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Operating Supply Voltage | 12V |
| Polarity | Non-Inverting |
| Number of Channels | 1 |
| Interface | Parallel |
| Max Supply Voltage | 16.5V |
| Min Supply Voltage | 5V |
| Test Frequency | 1MHz |
| Power Dissipation | 4.97mW |
| Max Supply Current | 380μA |
| Turn On Delay Time | 150 ns |
| Number of Inputs | 4 |
| Voltage - Supply, Single/Dual (±) | 5V~16.5V ±4.5V~16.5V |
| Supply Type | Dual, Single |
| Bandwidth | 170MHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Turn-Off Delay Time | 120 ns |
| Max Dual Supply Voltage | 16.5V |
| On-State Resistance (Max) | 1.8Ohm |
| Min Dual Supply Voltage | 4.5V |
| Dual Supply Voltage | 15V |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 80 dB |
| Current - Leakage (IS(off)) (Max) | 550pA |
| Channel Capacitance (CS(off), CD(off)) | 23pF 23pF |
| On-state Resistance Match-Nom | 0.13Ohm |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 150ns, 120ns |
| Insertion Loss (dB) | -0.35 dB |
| Charge Injection | -20pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Crosstalk | -100dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-on Time-Max | 510ns |
| Switch-off Time-Max | 380ns |
| Max Junction Temperature (Tj) | 150°C |
| Normal Position | NO |
| On-State Resistance | 1.5Ohm |
| Height | 1.2mm |
| Length | 5mm |
| Width | 4.4mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Contains Lead |
ADG1412YRUZ Overview
Due to its 16-TSSOP (0.173, 4.40mm Width) packaging, the electronic part is convenient for international shipping. To ensure high reliability, a new packaging method Tube is used. Surface Mount is where this multiplexer is located. 1:1 is the ratio of multiplexer to demultiplexer circuits. Around -40°C~125°C TA is the extended operating temperature. The total number of terminations is 16. A 1 channel electronic part produces high-quality output. When a voltage supply of 5V is used, the electronic component should be turned on and run. 16 pins are injected to the electronic part body. On the other hand, analog switches can be constructed using SPST - NO switching circuits. ADG1412 can be used to search for analog multiplexer variants. A 1.8Ohm internal resistance characterizes this multiplexer. The functions of 16 pins can be found in the datasheets. Multiplexer or Switches is a typical switch device. It is generally not recommended to supply a voltage higher than 16.5V to the switch device in normal circumstances. Analogue multiplexer with a Dual, Single supply type that is cost-effective. 5V is the lowest voltage that should be fed to the electronic electronic part. When the digital multiplexer is charged above 380μA, damage can occur. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 16.5V. A dual power supply should have at least 4.5V voltage attached. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. There is a voltage range of 12V operating voltages for the electrical part. In order to operate the 4 inputs, there are several steps to follow. This switch operates within the bandwidth of 170MHz.
ADG1412YRUZ Features
1 Channels
Switch Circuit: SPST - NO
Bandwidth: 170MHz
ADG1412YRUZ Applications
There are a lot of Analog Devices Inc. ADG1412YRUZ Analog Switches & Multiplexers ICs applications.
- High-Voltage
- Microprocessor controlled systems
- Access Concentrators
- Frame Relay Equipment
- Public switching systems
- Avionics
- Precision instrumentation
- Cable Modem
- Signal routing between systems
- Cable Telephony – NIU, Set-Top Box, Home Side Box