74ACT823SC
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 24-SOIC (0.295, 7.50mm Width) |
| Number of Pins | 24 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Series | 74ACT |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Type | D-Type |
| Voltage - Supply | 4.5V~5.5V |
| Base Part Number | 74ACT823 |
| Function | Master Reset |
| Output Type | Tri-State, Non-Inverted |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Number of Circuits | 9 |
| Clock Frequency | 158MHz |
| Propagation Delay | 9.5 ns |
| Turn On Delay Time | 5.5 ns |
| Logic Function | D-Type, Flip-Flop |
| Current - Quiescent (Iq) | 80μA |
| Current - Output High, Low | 24mA 24mA |
| Max Propagation Delay @ V, Max CL | 9.5ns @ 5V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 4.5pF |
| Number of Output Lines | 3 |
| Clock Edge Trigger Type | Positive Edge |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
74ACT823SC Overview
In the form of 24-SOIC (0.295, 7.50mm Width), it has been packaged. It is contained within the Tubepackage. There is a Tri-State, Non-Invertedoutput configured with it. This trigger uses the value Positive Edge. The electronic part is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. In the operating environment, the temperature is -40°C~85°C TA. There is D-Type type of electronic flip flop associated with this device. The 74ACTseries comprises this type of FPGA. Its output frequency should not exceed 158MHz. There are 1 elements in it. As a result, it consumes 80μA quiescent current. If you search by 74ACT823, you will find similar parts. The input capacitance of this T flip flop is 4.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. A part of the electronic system is mounted in the way of Surface Mount. A total of 24pins are provided on this board. A Positive Edgeclock edge trigger is used in this device. Despite its superior flexibility, it relies on 9 circuits to achieve it. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. There are 3 output lines in this JK flip flop.
74ACT823SC Features
Tube package
74ACT series
24 pins
74ACT823SC Applications
There are a lot of ON Semiconductor 74ACT823SC Flip Flops applications.
- Guaranteed simultaneous switching noise level
- Bus hold
- Buffered Clock
- Pattern generators
- Set-reset capability
- Storage Registers
- Reduced system switching noise
- Counters
- Clock pulse
- Balanced Propagation Delays