ADG719BRMZ
| Parameters | |
|---|---|
| Factory Lead Time | 8 Weeks |
| Lifecycle Status | PRODUCTION (Last Updated: 4 weeks ago) |
| Contact Plating | Tin |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tube |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Resistance | 4Ohm |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 315mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | ADG719 |
| Pin Count | 8 |
| Number of Outputs | 2 |
| Polarity | Non-Inverting |
| Power Supplies | 3/5V |
| Number of Channels | 1 |
| Interface | Parallel |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Operating Supply Current | 1nA |
| Nominal Supply Current | 1μA |
| Power Dissipation | 5μW |
| Max Supply Current | 1μA |
| Turn On Delay Time | 7 ns |
| Bandwidth | 200MHz |
| Turn-Off Delay Time | 3 ns |
| On-State Resistance (Max) | 4Ohm |
| High Level Output Current | 30mA |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Off-state Isolation-Nom | 67 dB |
| Current - Leakage (IS(off)) (Max) | 250pA |
| Channel Capacitance (CS(off), CD(off)) | 7pF |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 7ns, 3ns (Typ) |
| Crosstalk | -82dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 1.8V~5.5V |
| Drain to Source Resistance | 2.5Ohm |
| Height | 850μm |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Contains Lead |
ADG719BRMZ Overview
Shipping overseas is convenient with the electronic component packed in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). Advanced packaging method Tube is used to provide high reliability. The multiplexer is located in Surface Mount. Multiplexer and demultiplexer circuits have a number 2:1. The operating temperature is extended to around -40°C~125°C TA. Total terminations are 8. A high-quality output is provided by the electrical component's 1 channels. With a 3V voltage supply, the electrical component should be turned on and run. A key feature of the 8 series is the inclusion of this electronic part as part of its design. A SPDT switching circuit is used for these analog switches. ADG719 can be used to search for analog multiplexer variants. A 4Ohm internal resistance characterizes this multiplexer. For functions related to 8 pins, please refer to the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. A voltage higher than 5.5V should not normally be supplied to the switches. It is recommended that the electrical component receives a voltage of 1.8V. This digital switch can be operated with a current of 1nA. This analogue multiplexer requires a voltage of 1.8V~5.5V when it drains from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 1μA. There are various bandwidths available for data transfer. A Drain to Source resistance of 2.5Ohm is shown for this electronic part. A analog switch ics with 2 outputs is included.
ADG719BRMZ Features
1 Channels
Switch Circuit: SPDT
1nA Supply Current
Bandwidth: 200MHz
Drain-to-Source resistance: 2.5Ohm
ADG719BRMZ Applications
There are a lot of Analog Devices Inc. ADG719BRMZ Analog Switches & Multiplexers ICs applications.
- Automatic test equipment
- Microwave transmission systems
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Communication systems
- Signal routing between systems
- Relay Replacement
- Video signal routing
- Fiber In The Loop (FITL)
- Voice over IP/DSL – Integrated Access Devices, Smart
- PDH Multiplexers