74LVC2G66DC-Q100H
| Parameters | |
|---|---|
| Nominal Supply Current | 100nA |
| Max Supply Current | 200μA |
| Throw Configuration | SPST |
| Supply Type | Single |
| -3db Bandwidth | 500MHz |
| On-State Resistance (Max) | 10Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 37 dB |
| Current - Leakage (IS(off)) (Max) | 5μA |
| Channel Capacitance (CS(off), CD(off)) | 5pF |
| Switch Circuit | SPST - NO |
| Switch Time (Ton, Toff) (Max) | 3.9ns, 5ns |
| Charge Injection | 7.5pC |
| Crosstalk | -56dB @ 1MHz |
| Switch-on Time-Max | 13ns |
| Switch-off Time-Max | 11.5ns |
| Voltage - Supply, Single (V+) | 1.65V~5.5V |
| Height Seated (Max) | 1mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 8 Weeks |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-VFSOP (0.091, 2.30mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Series | Automotive, AEC-Q100 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| Resistance | 15Ohm |
| Max Power Dissipation | 250mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 2 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.5mm |
| Base Part Number | 74LVC2G66 |
| Pin Count | 8 |
| Number of Channels | 1 |
| Number of Circuits | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 200μA |
74LVC2G66DC-Q100H Overview
Shipping overseas is convenient due to the electrical component's packing in 8-VFSOP (0.091, 2.30mm Width). High reliability is ensured by the advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature around -40°C~125°C TA extended. Total terminations are 8. By its 1 channels, the electronic component provides high-quality output. Powered by a 3.3V voltage supply, the electrical part should be switched on and run. As part of its design, the 8 series is equipped with this electronic component. A SPST - NO switching circuit is used for these analog switches. It consists of 2 circuits. Try searching with 74LVC2G66 to find analog multiplexer variants. In this multiplexer, the internal resistance is 15Ohm. Datasheets for functions of 8 pins are available. A voltage higher than 5.5V should not normally be supplied to the switches. The digital multiplexer has a low cost Single supply. It is recommended that the electrical component receives a voltage of 1.65V. An operating current of 200μA would be sufficient for this switch device. Using only a single voltage supply, this analog switch requires 1.65V~5.5V voltage. A digital multiplexer may suffer damage if voltage is applied above 200μA. The Automotive, AEC-Q100 series contains it.
74LVC2G66DC-Q100H Features
1 Channels
Switch Circuit: SPST - NO
200μA Supply Current
-3db Bandwidth: 500MHz
74LVC2G66DC-Q100H Applications
There are a lot of Nexperia USA Inc. 74LVC2G66DC-Q100H Analog Switches & Multiplexers ICs applications.
- Remote wireless modules
- Residential Gateways, Home Gateway/Router
- SDH/SONET multiplexers
- Industrial
- Medical Instrumentation
- Fiber to the Home
- PCMCIA cards
- Intelligent PBX
- Automotive applications
- Digital access cross connects